Редактирование: Guide to Ordnance (раздел)

== [[File:Tachyon_Doppler.gif]] Doppler Array ==
The doppler array is able to capture explosions directly in front of it (indicated by the red light). If the source of the explosion is a tank, it will provide possible causes. These causal data are used to publish papers.

To safely detonate a tank and capture it, you will need to head to the Ordnance Launch Site, put the TTV in the [[File:Mass Driver.gif]] Mass Driver chamber and interface with the [[File:Airlock_Control_Panel.png]] control button. 

It might be useful to double check your doppler array to make sure it is on. <b>Explosions that occur when the doppler array is off will not be recorded and will be wasted!</b>

You can initiate a launch or open the door and test fire immediately for faster payload delivery. Once the TTV is in the bomb satelite and fully detonated (read the [[#Guide to TTV Assemblies|previous section]] for information on how to detonate your bomb), insert the[[File:Portable_Hard_Drive.png]]data disk into the doppler array and print it.

The requirement for the experiments can be read on NT Frontier, complete with available tiers and the target amount for them. Remember that the target amount only refers to the optimal explosion range for the experiment, not the minimum amount! If your range is too low from the target amount however, the experiment may not be published.

{| class="wikitable"
|+ Available Experiments
|-
! Experiment Name !! Requirements !! Other factors allowed !! Accepted By
|-
| Low-Yield || None || Yes || Mining Partner, Ghost Writing
|-
| High-Yield || Must be from a tank || Yes || Defense Partner, Ghost Writing
|-
| Hydrogen Bomb || Tritium Combustion and/or Hydrogen Combustion || No || Defense Partner, Ghost Writing
|-
| Noblium Bomb || Hyper-Noblium Condensation|| No || Physics Partner, Ghost Writing
|-
| Pressure Bomb || Tank overpressurized before reaction || No || Defense Partner, Ghost Writing
|}