Редактирование: Guide to Ordnance (раздел)

==[[File:BZ_canister.png]]BZ Synthesis==
BZ requires N2O and Plasma in a low pressure environment to produce. To use this you can use the freezer chamber to both cool down the reactants (drives the pressure down) and to give a larger area for the reaction to occur (also drives the pressure down).
[[File:BZ Setup Ordnance.png|thumb|Metastation Ordnance]]
# Wrench the [[File:Plasma_Canister.png]] plasma canister in to the first mixer port. Set the first mixer to 100% Side Node.
#: <b>Color Code:</b> Red
#: <b>Why:</b> As stated above, one of the ingredients for BZ is Plasma. For the mixer, they are supposed to mix two inputs, but in this case we do not need the oxygen at all so we can route all of the plasma in.
# Wrench the [[File:N2O_Canister.png]] N2O canister in to the second mixer port. Set the second mixer to 66.67% Main Node 33.33% Side Node.
#: <b>Color Code:</b> Pink
#: <b>Why:</b> As stated above, one of the ingredients for BZ is N2O. The ratio is 66.67% to 33.33% to keep the input and consumption the same. Other ratios might cause gas buildup inside the chamber
# Open the [[File:Dvalve.png]] valve connecting the Mix Line (yellow) with the Freezer line (purple)
#: <b>Color Code:</b> Orange
#: <b>Why:</b> This will redirect our mixed gas to the freezer chamber.
# Wrench a [[File:Plasma_Canister.png]] plasma canister into the freezer port. Turn the [[File:Freezer.gif]] thermomachine on and minimize the target temperature.
#: <b>Color Code:</b> Blue
#: <b>Why:</b> The [[File:He_pipe.png]] heat exchangers on the freezer turf will need gas to start exchanging heat, Plasma is an exceptional coolant since it [[Guide_to_atmospherics#Heat Capacity|absorbs a lot of heat.]]
# Open the [[File:AirAlarm.png]] air alarm and look for the scrubber inside the freezer chamber (match the id). Set it to expanded mode and to scrub BZ.
#: <b>Color Code:</b> Brown
#: <b>Why:</b> This will allow us to collect the BZ as they are formed in the chamber.
# Wrench a [[File:Canister.png]] canister or a [[File:PortablePump.png]] portable pump in the output port
#: <b>Color Code:</b> Light Blue
#: <b>Why:</b> The BZ collected by the chamber will be deposited to the canister or portable pump. The former is more readily available while the latter allows you to do gas shells very precisely.
# Look for the [[File:Atmostankcontrol.png]] Chamber Monitor, navigate to the Freezer Chamber selection, and in this order: Lower the injector to 1 L/S, and turn it on.
#: <b>Color Code:</b> Yellow, 
#: <b>Why:</b> This will be the final step that allows our reactants to go inside the chamber. You might be able to optimize it even further by adjusting the input rate up and down as time passes. Aim for somewhere below 50 kPa.

===Addendum===
If you overpressurized the gas inside the freeze chamber, you might want to:
# Disconnect the output canister.
# Set the scrubber to siphoning in the Air Alarm.
# Turn on the bypass volume pump.
Though this may not always work, such as when the input line is already at maximum pressure. You can then change the normal gas pump to a volume pump.