Участник:Denton

THE DENTON CENTER FOR KIDS WHO CAN'T MAP GOOD AND WANT TO LEARN HOW TO DO OTHER THINGS GOOD TOO

HOW2 MAP ATMOSIA

Each station should have a full set of these - or at the bare minimum, one for N2, one for O2 and a third tank to filter dangerous gases into.

Each gas tank needs:

Outside: A tank computer and a gas filter to pick what gases will be filtered into it.
Inside: A gas injector (input), a vent pump (output), a gas sensor and a specific turf.

The tank computer controls the input/output and receives data from the gas sensor.

The specific turf creates the gases that will be inside each tank - the gas canister is just for decoration.

Let's take a look at the MetaStation N2 tank:

Tank computer: /obj/machinery/computer/atmos_control/tank/nitrogen_tank
N2 filter: /obj/machinery/atmospherics/components/trinary/filter/atmos/n2
Gas injector: /obj/machinery/atmospherics/components/unary/outlet_injector/atmos/nitrogen_input
Vent pump: /obj/machinery/atmospherics/components/unary/vent_pump/siphon/atmos/nitrogen_output
Gas sensor: /obj/machinery/air_sensor/atmos/nitrogen_tank
Turf: /turf/open/floor/engine/n2

These objects have all the neccessary vars preset and start switched on - you'll only have to edit the dir if neccessary.

Additionally, you'll want this type of gas mixer for the airmix tank:

Навигация